Brush painting small, irregularly shaped details?

This is the place to get answers about painting, weathering and other aspects of finishing a model.

Moderators: DasPhule, Moderators

Post Reply
penguinpc
Posts: 48
Joined: Sat Dec 30, 2006 12:59 am
Location: McKinney, Texas
Contact:

Brush painting small, irregularly shaped details?

Post by penguinpc »

I am working a 1/2500 model of the Enterprise C. Now that I have done the base coat, I need to paint a few details. I attempted to do so with a very tiny brush, but try as I might, it's hard for me to stay in the "lines".

You can see my work at the link below.

http://www.flickr.com/photos/alvis_susan/9251619768/

Masking such small curved pieces seems like an impossibility, but maybe I should give it a try.

Ignore my other mistakes caused by my lack of patience. :)

Any suggestions on masking these details or how to paint them without them looking messy?

Thank you.
User avatar
Joseph C. Brown
Moderator
Posts: 7301
Joined: Thu Jul 11, 2002 6:13 pm
Location: Oak Ridge, TN, USA

Post by Joseph C. Brown »

Here are two possible approaches:

1) Find good quality masking tape, like Tamiya tape or Frog tape:
http://frogtape.com/index.php/products
This should allow you to mask right up to the edges of the detail areas. Burnish it down completely! Then paint the detail areas.


2) Strip the existing paint.

Then, paint each detail area as you wish, and ignore any 'wandering-brush' messy edges.

Then (use the appropriate tape) mask off each of your detail painted areas.

Then apply the base color.

Then remove the masking from the detail areas.

I'm sure other folks will chime in with more options.
________
Joe Brown
User avatar
Ramsayman
Posts: 3299
Joined: Sun Jan 09, 2011 2:03 am
Location: Penticton, BC

Post by Ramsayman »

I just use a "very fine" brush (sometimes even one bristle) and a light that I have with a magnifyer that looks like this!

It takes ALOT of patience. But that lamp makes it significantly easier!
kenlilly106
Posts: 1302
Joined: Sun Jan 14, 2007 12:18 am
Location: in the mountains

Post by kenlilly106 »

What I've done before is to take a new knife blade and lightly trace a path around the area to be painted, you don't need to press hard, the weight of the knife will make a slightly raised line in the paint, when you paint use the brush combined with the surface tension of the paint to flow the paint along this line, giving you a straight edge.

Ken
Targallian
Posts: 75
Joined: Thu May 23, 2013 8:52 pm
Contact:

Post by Targallian »

You could also try using Parafilm to mask it. It's very thin and flexible and can be wrapped around the area. I find it works pretty well on irregularly shaped areas.
irishtrek
Posts: 5757
Joined: Fri Sep 16, 2005 2:04 am
Location: wouldn't you like to know

Post by irishtrek »

When masking curved areas use a more narrow tape instead of the 1" wide masking tape, or just simply trim the wider tape into narrow strips.
Normal?? What is normal??
User avatar
Kylwell
Moderator
Posts: 29649
Joined: Sun Nov 02, 2003 9:25 pm
Location: Lakewood, CO
Contact:

Post by Kylwell »

Small brush, good lighting, magnifying visor. Do a basic coat, staying within the lines even if it means leaving a rough edge. Let dry then come in with a touch up coat to fix the lines, wee little bit @ a time. This may take more than one touch up session.
Abolish Alliteration
Post Reply